EN8, EN8D and EN19 are three of the most common grades on Indian shop floors. They look similar on a drawing, and are often swapped without much thought. They are not the same steel, and choosing the wrong one can mean a shaft that wears, bends or cracks early.
EN8: the general purpose medium carbon steel
EN8 (BS 970 080M40) is an unalloyed medium carbon steel with about 0.36 to 0.44% carbon. It machines well, has good tensile strength for its cost and can be flame or induction hardened.
Typical uses: general shafts, studs, bolts, pins, keys and machine parts that need more strength than mild steel.
EN8D: EN8 with tighter carbon control
EN8D (080A42) is very close to EN8, but its carbon is held in a narrower, slightly higher band, about 0.40 to 0.45%. That gives more consistent strength and a more predictable response to induction hardening from lot to lot.
Typical uses: automotive shafts, axles, spindles and parts that are induction hardened in volume. It is one of the most requested bright bar grades for auto components. It is broadly comparable to C45 and AISI 1045.
EN19: the chromium molybdenum alloy steel
EN19 (709M40) is an alloy steel with about 1% chromium and a small amount of molybdenum. Its closest common equivalents are 42CrMo4 and AISI 4140. When hardened and tempered it gives much higher strength and toughness than EN8 or EN8D, and it hardens deeper into the section.
Typical uses: high tensile shafts, gears, axles, heavy duty bolts and studs, and parts under shock or fatigue loads.
Quick comparison
| Grade | Type | Carbon (approx.) | Alloying | Best for |
|---|---|---|---|---|
| EN8 | Medium carbon | 0.36–0.44% | None | General shafts, studs, pins |
| EN8D | Medium carbon | 0.40–0.45% | None | Auto shafts, induction hardened parts |
| EN19 | Cr-Mo alloy | 0.36–0.44% | Cr about 1%, Mo | High tensile and shock loaded parts |
Values are typical ranges from BS 970. Always check the standard and condition called for on your drawing. Full ranges are on the chemical composition chart.
How to choose
- Moderate load, cost sensitive? EN8 does the job.
- Induction hardening in volume, or an auto customer drawing? Use EN8D for consistent results.
- High stress, shock loads or larger sections that must harden through? Step up to EN19.
Akansha Ispat supplies EN8D, EN19, 42CrMo4 and C45 as round, square and hex bright bars. Send your drawing and we will help you confirm the grade.
Frequently asked questions
Is EN8D the same as C45?
They are close but not identical. EN8D (080A42) and C45 (1.0503) are both medium carbon steels with similar carbon and are often treated as approximate equivalents.
What is the equivalent of EN19?
EN19 is broadly equivalent to 42CrMo4 (1.7225) and AISI 4140.
Which is stronger, EN8 or EN19?
EN19. As a chromium molybdenum alloy steel, hardened and tempered EN19 reaches much higher strength and toughness than EN8.