Square bright bars
Sharp, consistent corners and genuinely flat faces. Machine keys, tool parts, jigs, fixtures and block fittings are made from square bar because the section does the location work for you.
Akansha Ispat manufactures cold drawn square bright bars from 6 to 65 mm in 25 grades, supplied to ISO 286 class h11, with a Mill Test Certificate for every order.
| Size range | 6 to 65 mm |
|---|---|
| Process | Cold drawn |
| Typical tolerance class | h11 |
| Grades | All six quality groups, subject to size. See grades |
| Finish | Bright, smooth surface, straightened and polished |
| Typical uses | Keys, block fittings, tooling, fixtures |
| Length and quantity | Customised to your order |
| Documents | Mill Test Certificate with every product |
Three things that decide a square bar
Squareness of section
A square bar that has drifted into a rhombus will not seat in a keyway. Opposite faces must be parallel and adjacent faces at ninety degrees, within the drawn tolerance. We check section squareness as part of in-process inspection.
Corner radius
Cold drawn square bar carries a small natural corner radius. It cannot be a mathematically sharp corner, because the steel has to flow into the die. If your part needs a defined maximum radius, state it on the RFQ.
Straightness
Square section shows bow more obviously than round does, and a bowed bar fights the vice. Bars are straightened after drawing and checked before bundling.
What square bar becomes
Square bright bar is a smaller tonnage than round, but it is specified tightly, because most of it ends up as a part that has to locate something else.
- Machine keys and keyway stock. Usually EN8D or C45, sometimes supplied to a key steel tolerance rather than h11.
- Jigs, fixtures and tool bodies. EN8D, EN19 or EN24 where the fixture takes load.
- Block fittings and manifolds. Free cutting grades when the block is heavily drilled.
- Agricultural and transmission parts. Case hardening grades such as 20MnCr5.
Square bar weight, quick reference
| Size | kg per metre | Pieces per tonne at 6 m |
|---|---|---|
| 8 mm | 0.502 | 332 |
| 10 mm | 0.785 | 212 |
| 12 mm | 1.130 | 147 |
| 16 mm | 2.010 | 83 |
| 20 mm | 3.140 | 53 |
| 25 mm | 4.906 | 34 |
| 32 mm | 8.038 | 21 |
| 50 mm | 19.625 | 8 |
At 7.85 g/cm³. Formula: kg/m = 0.00785 × side². Full tool on the weight calculator.
Square bright bars: common questions
What size square bright bars does Akansha Ispat make?
Square bright bars from 6 to 65 mm, in 25 grades.
What tolerance do square bright bars hold?
Cold drawn square bars are commonly supplied to ISO 286 class h11 up to 80 mm, in line with IS 9550.
Do square bright bars have sharp corners?
Cold drawn square bar carries a small natural corner radius, because the steel has to flow into the die. If your part needs a defined maximum corner radius, state it on the enquiry.
Can you supply square bar as key steel?
Tell us the key standard and tolerance you work to and we will confirm what we can hold for that size and grade.
How do I calculate square bar weight?
Multiply the side in millimetres squared by 0.00785 for kilograms per metre, for steel at 7.85 g/cm3. A 25 mm square bar is 4.91 kg per metre.
Tell us the grade, size and quantity.
Send your requirement and our team will reply with availability and a quotation. Share a drawing if you have one.
+91 98193 91906